Working Group Members

CCM Working Group on Fluid Flow (CCM-WGFF)

Chair

Dr Bodo Mickan

Physikalisch-Technische Bundesanstalt

Germany

Vice-Chair

Dr Chunhui Li

National Institute of Metrology

China

CCM-wgff-tor

Terms of reference

The Working Group for Fluid Flow supports the CCM, the CIPM MRA, and NMIs to establish and maintain a validated and robust global measurement system for flow and related quantities:

  1. liquid flow (i.e. water, hydrocarbon liquids, cryogenic liquids),
  2. gas flow (air, nitrogen, natural gas, etc.),
  3. liquid volume (from microliters to thousands of liters), and
  4. the speed of fluids (air speed and water speed).

Within this objective, its tasks are to:

  • Facilitate the assembly of approved CMCs in the KCDB, including:
    1. ensuring that the general instructions, formatting, and inter-regional review process are followed,
    2. developing service categories that cover necessary measurands,
    3. ensuring the definitions of CMC uncertainty are clear and consistently applied,
    4. providing CMC review criteria in order to facilitate the CMC revision process,
    5. serving as a forum for discussion and resolution of questions raised during inter-RMO review of CMCs, and
    6. periodically reviewing CMCs for correctness.
  • Conduct comparisons to demonstrate the proficiency of NMIs and DIs and to verify that CMCs are correct, including:
    1. identifying where comparisons are needed,
    2. recommending comparisons to the CCM for approval,
    3. selecting pilot labs and participants,
    4. assisting pilot labs in developing protocols that meet the Guidelines for CIPM KCs,
    5. assisting or advising pilot labs with the data analysis and KC report writing,
    6. performing the Draft B KC report review process,
    7. assessing CMC uncertainty claims based on comparison results,
    8. reviewing regional comparison reports, and
    9. submitting comparison reports to the CCM for approval and posting on the KCDB;
  • Provide a forum of exchange between NMIs, DIs, and RMOs, provide supplementary guidelines and/or interpretations of CIPM and CCM policies for the flow measurement community, advise the CCM and the CIPM on flow related matters, and encourage and support laboratories developing new flow standards.

List of meetings

Meetings and related documents

Upcoming Meeting

CCM-WGFF
  • From 17 to 18
  • October
  • 2022

Past Meeting

CCM-WGFF
  • 22
  • April
  • 2021

Past Meeting

CCM-WGFF
  • From 19 to 20
  • March
  • 2018

Past Meeting

CCM-WGFF
  • From 22 to 23
  • September
  • 2016

Past Meeting

CCM-WGFF
  • From 13 to 14
  • April
  • 2015

CCM logo

Asset Publisher

Working Groups