Comparison
Comparison close
Results
Comparison
Comparison close
Results
Comparison
Comparison close
RMO comparison
Linked comparison
EURAMET.L-S22
Metrology area, Sub-field Length, Dimensional Metrology
Description Calibration of gauge blocks by mechanical comparison
Time of measurements 2013
Status Approved
Final Reports of the comparisons
Measurand Deviation from nominal length
Transfer device Eight steel gauge blocks of nominal lengths 0.5 mm, 1 mm, 6 mm, 7 mm, 8 mm, 20 mm, 50 mm, and 100 mm
Comparison type Supplementary Comparison
Consultative Committee CCL (Consultative Committee for Length )
Conducted by EURAMET (European Association of National Metrology Institutes)
RMO Internal Identifier EURAMET Project No 1254
Comments

Pilot institute DTI
Danish Technological Institute
Denmark
Contact person M. Holmberg
mahg@teknologisk.dk
+45 72 20 30 06
First Name Last Name
wwww@ww.www +356719836 Institute 1 Institute 1 Khmelnitskiy
Pilot laboratory
DTI

Danish Technological Institute, Denmark, EURAMET

AS METROSERT

Central Office of Metrology, Estonia, EURAMET

BEV

Bundesamt für Eich- und Vermessungswesen, Austria, EURAMET

BMM

Bureau of Metrology (Montenegro), Montenegro, EURAMET

CEM

Centro Español de Metrologia, Spain, EURAMET

DFM

Danish Fundamental Metrology Ltd, Denmark, EURAMET

LATMB

LNMC Metrology Bureau (LATMB), Latvia, EURAMET

MCCAA-SMI

Malta Competition and Consumer Affairs Authority - Standards and Metrology Institute, Malta, EURAMET

MIRS/UM-FS/LTM

MIRS/University of Maribor, Faculty for Mechanical Engineering/Laboratory for Production Management, Slovenia, EURAMET

NPL

National Physical Laboratory, United Kingdom, EURAMET

NSAI NML

NSAI National Metrology Laboratory, Ireland, EURAMET

VMT/VMC

State Metrology Service / Vilnius Metrology Center, now Vilnius Metrology Center/VI Vilniaus metrologijos centras, VMC, Lithuania, EURAMET

Comparison
Comparison close
Results
Comparison
Comparison close
Results